brondell Swash S1200-EW Manuel De L'utilisateur page 14

PRODUCT INSTALLATION (cont.)
SWASH INSTALLATION (cont.)
2. Turn Off Water Supply Valve and Flush Toilet
a. Turn water valve off to stop the flow of water.
b. Flush toilet and hold down handle to completely empty
tank.
c. Disconnect water supply hose from toilet tank. Do not
disconnect from the water supply valve.
NOTES:
• You may wish to place a container under the tank to
catch any excess water.
• Do not continue without completing the above steps
• Failure to do so could result in flooding, leaking or
damage to the Swash.
3. Connect T-Valve to the Toilet Tank Fill Valve
a. Place the flat edge of the rubber washer into the
T-Valve against the metal with the raised lip facing the
toilet tank connection.
b. Install the T-Valve with the rubber washer to the incoming
water connection on the bottom of your toilet tank.
NOTES:
• The T-Valve connects to the fill valve directly under
your toilet tank - it does not connect at the wall.
• Only connect to the cold toilet water supply line.
• If your water supply line is rigid you may need to
replace it before continuing.
4. Connect the water supply line coming from the wall to the
bottom of the T-Valve.
5. Install Mounting Plate
a. Place adjustable mounting plate over mounting holes
on toilet, rubber side faces down, curved edge faces
toward the toilet tank.
b. Place adjustable brackets flat side down in the center
of the square opening in the mounting plate and
insert mounting bolts through adjustable brackets and
mounting holes. Be sure that the square mounting bolt
head is even with sides of adjustable bracket.
c. Slide rubber cone washer, flat washer, and then barrel
nut onto mounting bolts under the toilet bowl and
tighten to keep mounting plate in place.
12
Step 2c
raised lip
(faces up)
Step 3a
toilet tank
t-valve
cold water
supply line
Steps 3-4
Steps 5b & 5c