Special Mode Operations - brondell Swash DS725 Advanced Bidet Toilet Seat Manuel Du Propriétaire

OPERATING THE SWASH (cont.)

SPECIAL MODE OPERATIONS

NOTE:
• Do not sit on the seat when programming Special Mode Operations. The process will not
work while the seat is occupied.
Seat Sensor Override
The Seat Sensor is activated at the factory by default.
Completing the following steps will bypass the seat sensor
located in the seat and allows the wash functions and dry
functions to operate without the sensor being engaged.
Use caution in this mode.
1. Unplug the Swash from the outlet or extension cord.
2. Press and hold the Night Light and Rear Wash buttons
on the auxiliary control panel, and plug the Swash back
in while continuing to hold the two buttons down.
3. If the water tank is full, you will hear a total of two beeps.
You'll hear one beep once the Swash has been plugged
back in. Keep holding the Night Light and Rear Wash
buttons down until you hear a second beep (about five
seconds later).
4. The second beep indicates that the Seat Sensor has
been overridden.
5. To reactivate the Seat Sensor, repeat Steps 1-3.
Activating/Deactivating Silent Mode
By default, the Swash will beep to confirm commands from
the remote control and auxiliary control panel. Follow the
steps below to silence the beeping sounds.
1. Press and hold the Night Light and Eco Mode buttons on
the auxiliary control panel
2. A beep will sound, indicating that Silent Mode has
been activated.
3. To deactivate Silent Mode, repeat Steps 1 and 2.
20
Steps 2 & 3
Steps 2 & 3