brondell Swash S1200-EW Manuel De L'utilisateur page 29

SWASH SPECIAL MODE OPERATIONS (cont.)
Selecting/Canceling Seat Sensor Lock Mode
This function bypasses the body sensor located in the seat and allows the wash functions and dry
functions to operate without the sensor being engaged. Use caution in this mode.
Seat Sensor Lock Mode is selected at the factory by default.
1. Press and hold down the Power and Rear Cleansing auxiliary buttons simultaneously
for approximately 5 seconds until one or more of the seat display lights start flashing. Release
the buttons.
NOTE: If the nightlight is turned on, it will also flash.
2. Press the Nozzle Cleansing button to Set or Cancel Seat Sensor Lock Mode.
a. If the Seat Temperature indicator light is flashing, this indicates that the Seat Sensor Lock
Mode has been set. Someone will need to be sitting on the seat for the unit to operate.
b. If the Seat Temp indicator light is not flashing, this indicates that the Seat Sensor Lock Mode
has been cancelled. Someone does not need to be sitting on the seat for the unit to operate.
Use caution.
3. The new setting will automatically be saved within 10 seconds if no other buttons are pressed,
or if you press the Stop button on the remote control.
Illuminating/Exstinguishing the Night Light
By default, the night light on the Swash will be constantly illuminated. Follow the steps below to
turn the night light off.
1. Press and hold down the Power and Rear Cleansing auxiliary buttons simultaneously
for approximately 5 seconds until all the seat display lights start flashing. If the nightlight is
turned on, it will also flash. Release the buttons.
2. Press the Rear Cleansing button and Nozzle Cleansing buttons simultaneously to Set or Cancel
the Nightlight.
a. If the Nightlight light is flashing, this indicates that the Nightlight has been set.
b. If the Nightlight light is not flashing, this indicates that the Nightlight has been cancelled.
3. The new setting will automatically be saved within 10 seconds if no other buttons are pressed,
or if you press the Stop button on the remote control.
ID Settings
The Swash 1200 and 1400 has the ability to pair a remote to a specific Swash seat. This is helpful
in cases where there is more than one toilet in the bathroom. For more information on how to
pair a remote to a Swash, please contact Brondell customer service.
27