Classe SSP-600 Manuel Du Propriétaire page 51

All manuals and user guides at all-guides.com
display setup This button brings up the display setup menu. It allows you to configure the SSP-600's
LCD screen brightness, the display timeout, and the language used in the touchscreen
and menu system. It also determines the format of your OSD (on-screen display), how
long the temporary display lasts on your main television (e.g., the message that appears
on your television when you change inputs or volume), and how volume settings are
displayed on your system.
brightness The brightness setting of the SSP-600 has three possible values: low, medium, and high.
Select the appropriate setting based on the level of ambient light typically found in your
listening room while using the system. A high brightness setting usually works best in
brightly-lit rooms; you may find that a lower setting is less visually intrusive under more
subdued lighting conditions.
timeout If you prefer listening to music in a dimly-lit or darkened room, you may find even
the low brightness setting of the display somewhat distracting. If so, you can vary the
timeout of the backlighting so as to turn it off entirely after a period of inactivity you
select.
In this context, activity refers to any use of the user interface. This includes hard buttons,
the LCD touchscreen, and the remote control.
For example, if you reduce the timeout to its minimum setting, the backlighting will
illuminate the display as soon as you interact with any of the SSP-600 controls, and
stay on for only three seconds–just long enough for you to check on something. If you
continue to use any of the controls (at least once every three seconds), the display will
remain lit. It will then extinguish itself after three seconds of inactivity on your part. Or
if you prefer, instead of a blank screen, after selecting the time in which the LCD will
turn off, and then selecting "video on timeout," the main video source will be shown on
the LCD.
51 51 51