Classe SSP-600 Manuel Du Propriétaire page 17

All manuals and user guides at all-guides.com
5 Now you are ready to power up your new SSP-600 and its associated
amplifiers.
Note that the initial power up takes approximately 90 seconds, during which time
the blue LED on the standby button will flash.
After approximately 45 seconds the LCD screen will display "initializing, please
wait...." Once this period is complete the LED light will remain on while the
LCD screen goes into standby mode.
A simple touch of the LCD screen will wake up the SSP-600 from its standby
mode. The LCD touchscreen will now display a blue screen titled "initializing" for
a further 15 seconds.
6 Connect the supplied calibration microphone to the MIC input on the
rear of the SSP-600, and use the auto-calibrate function of the SSP-600
to finish your initial setup.
The auto-calibrate function of the SSP-600 can be found by touching the
following on-screen "buttons" in the LCD display, in this order:
• Path: MENU/system setup/speakers/position 1/autocalibration
• touch auto levels (and wait for the autocalibration to finish)
• touch auto delays
Hold the microphone upright at arm's length so that it is approximately where
your head would be when seated at your preferred listening position, and pointed
at the ceiling.
Pink noise (at a low level) will automatically begin from the left front speaker
and rise slowly in volume. The SSP-600 generates this noise, listens through the
microphone, then increases the signal level gradually until the Sound Pressure
Level at the listening position is 75 dB. The SSP-600 will test every speaker in the
same sequence as described above and set their levels to 75 dB.
SPECIAL NOTE FOR SUBWOOFER
We have observed that, depending on the acoustics of your listening space, the
subwoofer distance auto-calibration may fail or return unreasonable results. If
this happens try one of the following solutions: If the subwoofer level was very
soft during the first pass of the auto-calibration process, increase it a bit to make
the signal more audible. Try raising the crossover frequency of the subwoofer (in
the Audio Setup menu) or turning the subwoofer filter off (which will make the
selected crossover frequency irrelevant). If all these measures fail, you will have to
enter the subwoofer distance manually through the Distance Setup menu.
Note: at this time you will only need to enter the manual level and distance values
for the subwoofer. All other speaker values will remain accurate.
To optimize speaker setup we suggest entering all speaker levels and distances
manually.
17 17 17