Tips And Warnings; General; Installation; In/Out Of Range Indicator - Alecto DVM-260+ Mode D'emploi

6

TIPS AND WARNINGS

6.1

GENERAL

• First read the manual carefully and follow all the instructions.
• Do not use or place the baby unit (s) or the parent unit in wet or humid environment.
• Ensure good ventilation for the heat; never cover the parent unit, the baby unit (s) and /or the
power adapter(s) and never place it directly next to a heat source.
• Only use the included power adapter(s), using another type of adapter may damage the
electronics.
• Make sure the power cables are not damaged, and ensure the wires will not lead to stumbling or
falling over.
• Never take apart the parent unit, the baby unit(s) and / or the power adapter(s), this should only
6.2

INSTALLATION

• Only connect or disconnect the power adapter of the baby unit or the parent unit when the power
adapter is not connected to an electrical outlet.
• Do not install the DVM-260 during a thunderstorm
• Do not touch an uninsulated adapter cord unless the adapter is disconnected from the electrical
outlet.
6.3 IN/OUT OF RANGE INDICATOR: (ONLY IN SINGLE CAMERA MODE)
• The top left of the screen of the parent unit will indicate the strength of the connection link from
the baby unit:
: very good connection link
: good connection link
: reasonable connection link
: moderate connection link
: bad connection link
• The picture and sound will show the same quality, regardless of the connection.
• When the parent unit does not receive a signal from the baby unit (out of range or the baby unit
is turned off), a no signal sign '
alarm tone every 15 to 20 seconds.
• When the parent unit receives a connection signal from the baby unit again, the light will come
on.
' followed by a no camera' icon in the window will sound an
71