Care And Maintenance - Alecto DOS-560C Mode D'emploi

Camera:
1. Use the "OFF 1 2 3 4" switch to select the cannel you want to use.
(select OFF to switch-off the camera).
2. Turn the camera on the observed subject.
Monitor:
1. Slide the "OFF ON
receiver.
2. Use button "CHANNEL" to select the same channel as you selected on the
camera.
3. You can control the audio level using the "VOLUME" controller.
4. Use buttons
In case the selected channel is disturbed or is in use by another transmitter, use
the "CHANNEL" switch to select another channel. The camera and the monitor
must both be set to the same channel.
Scan:
In case more camera's are to be observed, you can select the SCAN mode with
button "CHANNEL". With 6 seconds interval, all 4 channels are scanned and its
picture will come on the screen.
Sound only:
Slide the "OFF ON
image but to keep the sound.
- Only clean the monitor and the camera with a soft and moistures cloth.
Never use chemical cleansers.
- Avoid placing in a strong electromagnetic field or close to radio
transmitters, the audio and video quality might be disturbed.
- Do not locate the camera and/or monitor close to sensitive electronic
equipment.
- Do not place the camera and/or monitor in direct sunlight.
- The monitor is for indoor use only. Do not use the monitor in a moisture
surrounding.
- The use of the set under extreme conditions (temperature, moisture, etc),
might reduce the lifetime of the video observation system.
- At the end of the product lifecycle, you should not throw this product
into the normal household garbage but bring it to a collection point
for the recycling of electrical and electronic equipment.
All manuals and user guides at all-guides.com
USAGE
LCD-OFF" switch into position ON to switch-on the
and to adjust the brightness.
LCD-OFF" switch into position LCD-OFF to switch-off the

CARE AND MAINTENANCE

14