Care And Maintenance - Alecto DOS-150+ Mode D'emploi

All manuals and user guides at all-guides.com
Camera:
1. Use the "OFF 1 2 3 4" switch to select the cannel you want to use.
(select OFF to switch-off the camera).
2. Turn the camera on the observed subject.
Monitor:
1. Use the "POWER" switch to turn "ON" the monitor and use the CHANNEL
button to select the same channel as you selected on the camera
2. Set the "SCREEN" switch to "ON".
3. You can control the audio level using the "VOLUME" controller.
4. On the backside of the monitor you can adjust the V-hold, brightness and
contrast.
In case the selected channel is disturbed or is in use by another transmitter, use
the "CHANNEL" switch to select another channel. The camera and the monitor
must both be set to the same channel.
Scan:
In case more camera's are to be observed, you can select the AUTO mode with
button "CHANNEL". With 6 seconds interval, all 4 channels are scanned and its
picture will come on the screen.
- Only clean the monitor and the camera with a soft and moistures cloth.
Never use chemical cleansers.
- Never locate the monitor close to a magnet (loudspeakers), the image will
warp. Avoid placing in a strong electromagnetic field or close to radio
transmitters, the audio and video quality might be disturbed.
- Do not locate the camera and/or monitor close to sensitive electronic
equipment.
- Do not place the camera and/or monitor in direct sunlight.
- The monitor is for indoor use only. Do not use the monitor in a moisture
surrounding.
- The use of the set under extreme conditions (temperature, moisture, etc),
might reduce the lifetime of the video observation system.
- Please take care when disposing of this product. At the end of this
products life it should be entered into a recycling scheme. It should
not be disposed of in normal domestic waste.
USAGE

CARE AND MAINTENANCE

14