Assembly - Casada SKYLINER A300 Mode D'emploi

Assembly

ASSEMBLING THE ARMREST
1. Locate the connector and the air hose which can be found on the side of the seat part. (Illustration 1).
2. After feeding the connector and the air hose through the metal device, link each connection with its
counterpart on the armrest. Please ensure when plugging in the cables that you always plug in the same
colours together! (Illustration 2+3).
3. After linking the connections to each other, feed the protruding cables back into the seat part. Be careful
that the plug-in connectors and the air hose do not bend or jam. (Illustration 4).
Illustration 1
Illustration 3
4. In the inside of the armrest there are 4 mounting hooks which are required for fixing. Please loosen any
possible pre-assembled screws and then attach them in step 9 of the assembly instructions. Please refer
to Illustration 5 for corresponding numbering.
5. Insert the side section at a slight angle beginning with hook 1 into the upper rail on the device. Push this
downwards so that hooks 2 and 3 finally lock into place. Press lightly on the level of hook 4 against the
outside of the armrest, this should engage easily. Please do not exert a great deal of pressure. It is better
to check whether the side section has not been inserted too far back. (Illustration 5+6).
Illustration 5
Armrest
hooks-
3
3
underside
2 armrest
1 2
hooks- 1
upper side
28
3
1
Illustration 2
Illustration 4
Screws
4
4
Armrest
hooks-
front part
2
NOTE: The connecting cable must be in
the right place in order to avoid jamming.
Assembly
4
2
Illustration 7
Illustration 8
Illustration 6
Illustration 9
Note
Please be careful and cautious when installing the armrest in order to avoid damage.
7. Then slide the armrest back towards the backrest and ensure that
the hooks are fully engaged. (Illustration 7)
8. There is a mounting hole on the right and left hand side of the front
interior in order to fix the side section with a screw. To do this, raise
the front side of the seat cushion in order to reach the hole. Fasten
Seat cushion
the hex bolt with the Allen key provided. (Illustration 8)
9. There is another mounting hole on the rear inside wall between
the back and side sections (on the left and right). In order to reach
Armrest
this, whip the backrest cover to the side. Fasten the hex bolts.
(Illustration 9)
29