Assembly / Startup; Troubleshooting - Casada QUATTROMED V Mode D'emploi

Assembly / Startup

1. Open the box, remove the power supply unit and place it within reach.
2. Take the black fabric bag out of the box carefully, open the zip fastener and remove the Quat-
tromed V and the seat cushion packaged in protective film.
3. Remove the protective film.
4. The overlay/cover can be separated from the backrest via a Velcro fastener. Remove the protective
cardboard between the two before first use. A padded backrest flap is provided for a gentler mas-
sage. Remove the backrest flap if you prefer more intense massage
5. Back and seat section are not connected to each other at the time of delivery. For parallel use,
remove the remote control from the pocket in the seat section and now attach both parts via the zip
fastener.
(Illustration 1)
6. Then plug the cables together as shown. (Illustration 2)
7. Position the Quattromed V on a suitable chair or armchair. The massager is equipped with back
strap that allow user to faster onto most chairs. Place the massager on a chair, wrap the two end of the
strap at the back of the chair then secure with Velcro.
8. Finally, connect the power supply unit with the connection cable (Illustration 3), plug the power plug
into the socket and turn the Quattromed V on using the red „ON/OFF" button.
REMOVING LOCKING SCREW
Carefully loosen the screw with the attached Allen key on the back of the massage device. A screw
is applied on the back of the product to protect the Quattromed apparatus during shipment. Remove
the screw before use.
The screw is not to be used again. Just remove it.
ATTENTION!
(Illustration 2)
18
(Illustration 1)
(Illustration 3)

Troubleshooting

FAULT
The device is connected to the mains,
•
however neither the device nor the re-
mote control operation work.
The device is connected to the mains.
•
The vibration in the seat is running and
cannot be switched off. Remote control
and massage do not work.
The device is connected to the mains.
•
Vibration massage does not work.
REMEDIAL ACTION
Check whether all connections are cor-
•
rectly paired. Ensure that the power sup-
ply is fully connected.
The device can overheat if used perma-
•
nently. Therefore, turn it off, disconnect
it from the mains power supply and let it
cool down completely.
Check whether the connectors are cor-
•
rectly paired for the vibration and pow-
er supply unit.
19