Transportation - Casada SKYLINER A300 Mode D'emploi

Assembly
FITTING AND USING THE HEAD AND BACKREST CUSHION
Please connect the backrest cushion as shown in (1) via the practical zipper on the massage chair. To clean
the backrest cushion easily you can separate it from the chair at any time with the zipper. We would strongly
advise that you do not use the massage chair without the backrest cushion. Please fasten the pillow using the
Velcro strips on the upper part of the back cushion (2).
FLOOR PROTECTION
In order to prevent excessive wear and tear of your floor covering due to the heavy weight of the massage
chair, we recommend placing carpet or similar underneath the chair.
Note:
Do not move the massage chair on uneven or sensitive floor coverings. In such cases at least 2 people
should move the chair. To do this, lift the chair using the handle on the back section and the footrest.
This way the footrest is completely folded up.
30
Zipper Velcro strip
Assembly
There are 2 sensors in the rear safety cover over the rollers on the massage chair. These prevent the
complete function of the massage chair if the cover is placed under stress. Always ensure that there are
no objects or persons behind the massage chair during treatment.

Transportation

Ensure that all cables are far from the ground.
Slide the chair on the backrest to the desired position and carefully set
it upright again.
Note:
Before transportation the electric power supply
must be switched off and the power cable with
the remote control cable must be disconnected.
31