Lap Belt Installation - Britax Boulevard 65 CS Guide D'utilisation

Rear-Facing Installation

Lap Belt Installation

Before You Begin:
• Check that your vehicle belt is compatible for use with child
seats. See pages 8 – 13 for more information.
• This child seat must be reclined to position 3 when
installed rear-facing.
* When properly installed in the rear-facing
position, the back angle of the child seat
should be at least 30˚ for children and up
to 45˚ from vertical for infants unable to
maintain head and neck control (not to
exceed 45˚) when the car is parked on a
level surface. Use the blue line as a guide to
achieve the proper recline angle for rear-
facing installations. The blue line will be
parallel to the ground when the child seat angle is at the center
of the angle range (30 – 45˚). If necessary, the proper recline
angle can be achieved by placing a rolled towel or pool noodle
in the vehicle seat bight.
• Britax recommends that the Versa-Tether is used at all times.
Using the tether will improve the stability of the child seat and
reduce the risk of injury. Check your vehicle owner's manual for
tether anchor locations. See page 27 for possible rear-facing
tether configurations.
38
All manuals and user guides at all-guides.com
Install with lap belt as shown above.
ImpoRtANt: The harness buckle strap should lie toward
the back of the child seat during installation.
Rear-Facing Installatio
39