Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation: Rear-Facing
Lap-Belt Installation
•
Figure A illustrates a rear-facing, lap-belt
installation.
•
When not in use, always store the LCS
connectors in the storage slots. See page 33.
1
Recline the child seat, then place it rear facing
on the vehicle seat. This child seat must be in
the recline position when installed rear-facing.
Recline Adjustment
See
on page 33.
2
Lift the cover and open the rear-facing lock-off
farthest from where the vehicle belt will be
buckled (Fig. B).
3
Pull the vehicle belt out, then pass it
LCS bar, through the rear-facing belt slot and
(Fig. C).
•
The vehicle belt can be routed over or under
cover.
4
Route the vehicle belt across the child seat
then through the opposite rear-facing belt slot
and under the LCS bar.
IMPORTANT: The vehicle belt must rest behind the
child seat buckle strap.
5
Verify that the vehicle belt is not twisted,
position the belt through the open lock-off,
then buckle (Fig. D).
6
Push the child seat firmly into the vehicle seat
while removing slack from the vehicle belt.
7
Tighten the belt, close the lock-off arm and
replace the cover (Fig. E).
•
The lock-off is properly closed when a click is
heard.
•
To prevent damage, never extend the lock-off
arm beyond its normal open position and always
keep the lock-off closed when not in use.
•
If your vehicle is equipped with an automatic
locking retractor (ALR), use of the lock-offs
is not required as long as the ALR is locked.
20
All manuals and user guides at all-guides.com
a
under the
b
c
d
Check your vehicle owner's manual to
determine the type of retractor your vehicle
has, and how to lock the retractor.
8
Verify that vehicle belt is tight, locked, and that
the child seat is secure.
•
The child seat is secure when it cannot be
moved more than 2.5 cm (1 in.) front-to-back
or side-to-side at the belt path. If the child seat
is not secure, repeat the installation process
or use an alternate seating location.
WARNING!
Do not use this seat
with a non-locking, two-point Emergency
Locking Retractor (ELR) vehicle belt.
•
When properly installed in the rear-facing
position, the back angle of the child seat
should be 30º – 45º from vertical (not to
exceed 45º) when the car is parked on a level
surface (Fig. F).
•
If necessary, the proper recline angle can be achieved by placing a
rolled towel or pool noodle in the crease of the vehicle seat to level the
child seat's base.
WARNING!
Do not raise the child seat off the front edge of
the vehicle seat. This could cause your child seat not to perform as
intended.
•
Rear-facing installation can be improved by the use of the Versa-Tether.
See pages 29 – 32.
Installation: Rear-Facing
e
f
21
Publicité
Chapitres
Table des Matières
