Britax Boulevard 65 CS Guide D'utilisation page 26

Forward-Facing Installation
1 Loosen the harness.
a Lift harness adjuster lever
b Pull both harness straps forward
2 Remove the body pillow and
unbuckle the harness.
3 Pull the head restraint cover up,
then pull the seat cover forward to
access the forward-facing belt path.
4 Open the red lock-off closest to
where the vehicle belt will be
buckled.
a Pull the locking tab up
b Pull the clamp down
5 Route the vehicle belt through
the forward-facing belt slots, then
buckle.
TIP: Ensure the vehicle belt is not twisted.
Remove excess slack from the bottom
(lap) part of the vehicle belt before
closing the lock-offs.
6 Ensure that both parts of the
vehicle belt are routed through the
lock-off, then close the lock-off.
a Push the clamp up
b Push the middle of the locking tab
down until locked
7 Push the child seat into the vehicle
seat while pulling the top (shoulder)
part of the belt between the belt
slots (pull away from the buckle) to
remove slack.
TIP: The shoulder part of the vehicle belt
must be on top when removing slack.
48
All manuals and user guides at all-guides.com
1b
1a
LOCKING 4a
TAB
CLAMP
4b
5
7
8 Pull slack through the belt slot
toward the vehicle belt retractor
9 Attach the Versa-Tether to a
designated anchor (see vehicle
owner's manual) and remove slack.
10 Store excess webbing in the
elastic strap.
11 Replace the cover.
Check Versa-Tether
(Top Tether) attachment
Check that no more than
20% or 7.6 cm (3 inches)
of the base hangs over the
edge of the vehicle seat
Check that there is
LESS than 2.5 cm (1 in.)
of movement (front to back or
side to side) at the belt path
Checklist
9 Check that the vehicle belt is securely fastened.
9 Check that no more than 20% or 7.6 cm (3 inches) of the base hangs
over the edge of the vehicle seat
9 Check that the child seat cannot be moved front to back or side to side
more than 2.5 cm (1 in.) at the belt path. If the child seat is not secure,
repeat installation or use a different seating location.
9 Check that any excess Versa-Tether
vehicle and secured in the elastic strap.
Forward-Facing Installatio
8
®
Check that Versa-Tether
®
(Top Tether) webbing is
stored in the elastic strap
Check buckle
connection
webbing is contained within your
®
49