Britax Boulevard 65 CS Guide D'utilisation page 18

Rear-Facing Installation
Place the child seat on the
1
vehicle seat.
Firmly press the lower
2
connectors onto the adjacent
lower anchors.
• A click confirms attachment.
• Verify that the lower connector
strap is not twisted.
TIP: You may need to turn the front
of the child seat toward you
for easier access to the lower
anchors.
NOTE: If a click is not heard when
connecting either lower connector,
the lower connector strap may be
twisted, or there may be debris in
the lower connector. Correct either
situation before continuing with the
installation process.
Push the child seat into the
3
vehicle seat while pulling
each lower connector strap to
tighten.
Rear-facing installations can
4
be improved by the use of
the Versa-Tether (see pages
26 – 29).
32
All manuals and user guides at all-guides.com
1
2
3
Check that the
child seat is
reclined to position 3
Check that there is
LESS than 2.5 cm (1 in.)
of movement (front to back or
side to side) at the belt path
Checklist
9 Check that all connections are secure.
9 Check that the lower connector straps are not twisted.
9 Check that the child seat cannot be moved front to back or side to side
more than 2.5 cm (1 in.) at the belt path. If the child seat is not secure,
repeat installation or use a different seating location.
9 Check that the back angle of the child seat is 30º – 45º from vertical (not
to exceed 45º) when the car is parked on a level surface
* If necessary, the proper recline angle can be achieved by
placing a rolled towel or pool noodle in the vehicle seat bight.
Rear-Facing Installatio
Check lower
connector
attachments
.
33