Resetting To The Factory Default Settings; Further Information - Eneo IPC-52A0030P0A Guide D'installation Rapide

i Notice: If the password is lost, the network camera must be reset to the factory
default settings. Please see "Resetting to the Factory Default Setting".

Resetting to the factory default settings

To reset the network camera to the original factory settings, go to the Setup > System >
Maintenance web page (described in "System > Maintenance" of User's Manual) or use
the Reset button on the network camera, as described below:
Using the Reset button:
Follow the instructions below to reset the network camera to the factory default settings
using the Reset button.
1. Switch off the network camera by disconnecting the power adapter.
2. Press and hold the Reset button on the board with your finger while reconnecting
the power.
3. Keep the Reset button pressed for about 2 seconds.
4. Release the Reset button.
5. The network camera resets to factory defaults and restarts after completing the
factory reset.
CAUTION: When performing a Factory Reset, you will lose any settings that have been
saved. (Default IP 192.168.1.10)

Further information

Make sure to always upgrade to the latest firmware version available from the eneo web-
site at www.eneo-security.com to receive the latest functionality for your product.
The manual, and other software tools are available on the eneo website at www.eneo-se-
curity.com or on the included CD.
16
Reset button