Resetting To The Factory Default Settings; Using The Reset Button; Further Information - Eneo NXD-980IR3516P B Guide D'installation

Table des Matières

Les langues disponibles

To reset the Network Camera to the original factory settings, go to the

Setup>System> Maintenance web page (described in User's Manual, "3.5.5

System > Maintenance") or use the Reset button on the network camera, as

described below

Reset Button

Follow the instructions below to reset the Network Camera to the factory

default settings using the Reset button.

1. Switch off the Network Camera by disconnecting the power adapter.

2. Press and hold the Reset button with a straightened paperclip while

reconnecting the power.

3. Keep the Reset button pressed for at least 2 or more seconds.

4. Release the Reset button.

5. The network camera resets to factory defaults and restarts after com-

pleting the factory reset.

CAUTION: When performing a Factory Reset, you will lose any

settings you have saved. (Default IP 192.168.1.10)

The User's Guide is available on the eneo website at

www.eneo-security.com or on the included CD.

Resetting to the factory default settings

Table des Matières