Resetting To The Factory Default Settings; Using The Reset Button - Eneo IPP-83A0036MIA Guide D'installation Rapide

Resetting to the factory default settings

To reset the network camera to the original factory settings, go to the Setup > System >
Maintenance web page (described in "System > Maintenance" of User Manual) or use the
Reset button on the network camera, as described below:

Using the Reset button:

Follow the instructions below to reset the network camera to the factory default settings
using the Reset button.
1. Switch off the network camera by disconnecting the power adapter.
2. Open the Micro-SD card cover.
3. Press and hold the Reset button on the board with your finger while reconnecting
the power.
4. Keep the Reset button pressed for about 2 seconds.
5. Release the Reset button.
6. The network camera resets to factory defaults and restarts after completing the
factory reset.
7. Close the Micro-SD card cover tightly to ensure waterproofing.
CAUTION: When performing a Factory Reset, you will lose any settings that have been
saved. (Default IP 192.168.30.220)
10
Reset Button
Micro-SD Card Slot