Operating Instructions; Using Osd Controller; Description Of The Joystick Operation; Description Of The D-Zoom Adjustment - Eneo TPD-62V2812P0A Guide D'installation Rapide

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Operating instructions

Using OSD controller

Setup menu can be accessed and controlled by OSD control joy stick on the gimbal of the
camera unit. Five commands are available with the joy stick.
OSD control Joy Stick
CAUTION: Extreme care should be taken NOT to apply force to
the IR LEDs.

Description of the joystick operation

1. SET Key (●) : Access to the menu or enter the setting. To enter the main menu,
press the Set Key down for about 1.5sec
2. UP/DOWN Key (▲/▼) : Choose the desired sub-menu and to move the cursor up or
down.
3. LEFT/RIGHT Key (◄/►) : Set up the value of the selected menu. Used to adjust the
desired menu selection and to move the cursor left or right.
4. '☟' denotes the long press down straightly for about 2 seconds

Description of the D-ZOOM adjustment

Works only when OSD Menu is inactive. Set to pointing zoom ON for D-Zoom
i
control.
1. ▲ : Zoom In
2. ▼ : Zoom Out
IR-LEDs
11
EN

Publicité

Table des Matières
loading

Table des Matières