Vaisala HMDW110 Serie Guide Rapide page 9

1. Open the six screws that hold
the transmitter cover.
2. Route the power and signal
cable through the cable gland,
and connect the wires to the
screw terminals according to
the wiring instructions:
Wiring HMDW110 on
o
page 10
Wiring HMDW110 with
o
RDP100 on page 11
For the arrangement of the
screw terminals, see section
Component Board on page 9.
3. Adjust the length of cable
between the cable gland and the
terminal blocks. Make the cable
short enough to close the cover
without leaving a cable loop in
the transmitter.
4. Disconnect the wired screw
terminal blocks by pulling them
off from the component board.
EN
DE
FR
JA
ZH
RU
7