Vaisala HMDW110 Serie Guide Rapide page 5

HMD110/112 Installation
Medium size crosshead screwdriver (Pozidriv) for screws
n
on cover and flange.
Small slotted screwdriver for screw terminals.
n
Drill with 2.5 mm and 13 mm bits for making the installation
n
holes.
Tools for cutting and stripping wires.
n
19 mm open-end wrench for tightening the cable gland.
n
1. Remove the yellow transport protection cap and separate the fastening
flange from the transmitter.
2. Use the flange to mark the location and size of the installation holes on
the side of the duct.
3. Drill the installation holes in the duct. Secure the fastening flange to the
duct with the two screws (included).
EN
DE
FR
JA
ZH
RU
3