Serial Commands - Vaisala HMDW110 Serie Guide Rapide

Serial Commands

For more information and examples of using the serial
commands, refer to the HMDW110 Series User's Guide.
Command
Device information and status
?
??
errs
help
system
time
Serial line output and communication
addr
close
form
intv
open
r
s
sdelay
send
seri
smode
unit
Analog output
aerr
amode
aover
14
Description
Show device information.
Show device information (will respond in poll mode).
Show active errors.
Show list of serial commands.
Show firmware information.
Show transmitter uptime (time since last reset).
Show or set device address.
Close connection to device in POLL mode.
Set output format of measurement messages.
Set measurement output interval.
Open connection to device in POLL mode.
Start continuous output of measurement messages.
Stop continuous output of measurement messages.
Show or set serial line turnaround delay.
Output one measurement message.
Set serial line settings. Default is 19200 N 8 1.
Set serial line operation mode.
Set units to metric (m) or non-metric (n).
Show or set error level for analog output.
Show analog output settings.
Enable or disable analog output 10% over range.