Vaisala HMDW110 Serie Guide Rapide page 6

4. Push the probe of the transmitter through the flange and into the duct.The
probe should reach far enough so that the sensor is located in the middle
of the duct.
5. Secure the transmitter to the flange by tightening the screw on the flange
that holds the probe in place.
6. Open the transmitter cover, and route the cables through the cable
glands. Connect the wires to the screw terminals according to the wiring
instructions:
Wiring HMDW110 on page 10
o
Wiring HMDW110 with RDP100 on page 11
o
For the arrangement of the screw terminals, see section Component
Board on page 9.
7. Tighten the cable gland(s) and close the transmitter cover.
4