Direct Healthcare Group QUATTRO Acute Manuel D'utilisation page 10

EN
5.4 Patient Transport Facility (Fig. 8)
Press MAX. INFLATE button to fully inflate the mattress. When maximum
FR
pressure is achieved, detach the mattress air supply hose from the
power unit by rotating the mattress hose connector anti-clockwise until
the black lines align, and pull the mattress hose connector away. The
mattress will remain inflated, so supporting the patient.
5.5 NFC (RFID) (Fig. 9)
DE
The power unit contains a passive NFC tag which contains supplementary
information and can be interrogated at any time by a compatible NFC
enabled device (such as a smartphone or tablet). Place the device over
the NFC symbol on the top of the product and the following will be
displayed on the device:
ES
• Model
• Part number (REF)
• Serial number (SN)
• Manufacturer contact details (TEL)
Please note you may need to download an NFC read app to view
information.
IT
5.6 Additional Operation Information
• Allow the mattress to inflate before positioning the patient on the mattress.
• Mattresses can be used on profiling bed frames, slatted frames, in-filled frames and divans.
• Back rests or pillows for support should be placed beneath the mattress to allow uninterrupted body contact with
NL
the mattress surface.
• Place the bottom sheet loosely on the mattress to allow the mattress surface greater contact with the patient's body.
Avoid using fitted sheets. The use of incontinence sheets / excessive bedding beneath the patient may reduce the
pressure relieving effect of the mattress.
• To remove air from the mattress when dismantling the system, use the CPR device as described above.
• Care should be taken when raising and lowering bed safety side rails in order to avoid possible interference
EL
with the mattress air supply hose, the CPR and cushion connection port where fitted.
• A gap of 2.5cm on either side of the mattress should not be exceeded when side rails are deployed.
Min. - Max. Patient Weight / Max. Load Guidelines
FI
6. Care and Maintenance
NO
6.1 Mattress - Exterior Components
• Always keep the cover as clean as is practicable. The material is waterproof and vapour permeable.
• Inspect top cover for signs of damage or wear which could result in the contamination of the interior, e.g. tears,
holes, damage to seams or zips, underside staining, etc. The frequency of these checks should be at each
decontamination process, i.e. between patients or patient occupancy (or weekly for longer term patients).
DA
• Care should be taken to avoid puncturing cover with objects such as needles, scalpels, pat slides, acrylic nails, etc.
• The cover may be removed and cleaned in accordance with The Revised Healthcare Cleaning Manual June 2009
subject to the following action: Following the use of a detergent and or disinfectant solution the cover should be
rinsed with clean water using a clean cloth and allowed to dry.
SV
8
Q U A T T R O
®
QUATTRO Acute:- 0-250 kg (0-39 stone)
QUATTRO Plus:- 0-200 kg (0-31 stone)
B.A.S.E. SEQUENTIAL cushion:- 0-127 kg (0-20 stone)
D I R E C T H E A L T H C A R E G R O U P. C O M
A C U T E & Q U A T T R O P L U S
®
Fig. 8
Fig. 9