Koshin SEV-25L Manuel D'utilisation page 9

4.SARTING
1. To start the pump turn on the engine switch.
2. Press the priming button repeatedly with a
finger till it touches the bottom.(In order to
pump up the fuel and ensure a smooth start.)
3. Move the choke lever to the fully closed position.
(Lift up the lever upwards)
When fuel is remaining and the engine and the
engine is warm, move choke lever to the fully
open position.(Pull down the lever.)
4. Move the throttle lever to the position newer the
center between the low speed and high speed
position.
5. Grasp the recoil starter knob and pull it rapidly.
6. After starting, watch the engine condition and
move the choke lever slowly to the full open
position.(Pull down the lever.)
Note:When the explosion sound is heard, but the
engine does not start, move the choke lever
to the full open position and again pull the
starter knob rapidly.
This engine is of construction that the fuel
returns to the fuel tank when the priming
pump is operated. Even if the pump is operated
a little too much, the fuel will not be pumped up
excessively, it shoud be operated sufficiently.
Because, when it is insufficient starting trouble
may be raised.
- 7 -
1
2
3
4
high
low
5
6
EN