Fuel Supply - Koshin SEV-25L Manuel D'utilisation

CAUTION
1.Application
1.Application
As this pump is exclusively used for agriculture,
do not apply muddy water.
*Trouble if you don't observe.
Damage of mechanical seal
2. Priming
As this pump is of self-priming type, pour water
fully from priming port before running.
*Trouble if you don't observe.
Impossible pumping
Damage of mechanical seal

3. Fuel supply

Fill the fuel tank with the fuel. Be sure to stop the engine before supplying the
fuel. Fuel to be used; Mixture of oil and gasoline mixed at the ratio of 50
(lead-free gasoline):1(oil).
When the quality of mixed oil is low, the ignition plug is contaminated excessively
and an increased amount of carbon accumulates in the muffler and cylinder.
Be sure to use the oil specially made for 2 cycles and sold by each petroleum
maker in the commercial market.
4. Connection of suction hose
If priming is not made by running after pouring water from priming port, it is
almost because of imperfect connection of suction hose. In such sa case, run
after checking again connectin of hose.
*Trouble if you don't observe.
Impossible pumping
5. Drain of water after use
Water inside casing freezes at below 0℃ in winter and thereby pump may
possibly be broken. After use, drain water from drain port at bottom to store.
*Trouble if you don't observe.
Breakage of pump casing
1
PRIMING
PLUG
DRAIN PLUG
- 3 -
EN