System Connections; Bench-Top System - MSA Galaxy Manuel D'instructions

System Connections

Figure 2-4. System Connections
• Allows cylinder holder, memory card and network interface sharing
• System limits are 10 test stands (in any combination of instruments
desired), and three cylinder holders
• Cylinders must be installed on the left-hand side of the system
• Network interface modules must be installed on the right-hand side
of the system.
• Memory card must be installed in right-most Test Stand.

Bench-top System

1. Remove the screws on the front and rear of the left-hand side
connection flange of each unit to be installed and save them for
step 5.
2. Remove the four white tubing plugs located on the right-hand side
of all Test Stands except for the last Test Stand (the one to be
furthest to the right). Remove the Fresh Air filter and tubing from
the left-hand side of each Test Stand. Be sure to replace the barb
fitting in the Test Stand upper port after removing the filter.
2-4