Wall Mount Unit (Figure 2-2); Wall Mount Unit (Single Test Stand) - MSA Galaxy Manuel D'instructions

Wall Mount Unit (FIGURE 2-2)

Wall Mount Unit (Single Test Stand)

1. Mount the upper DIN rail to the wall by securing it with wall
anchors or other suitable fasteners.
2. Align the upper channel on the rear of the Test Stand with the
upper DIN rail and slide the Test Stand on and into position.
3. Align the lower DIN rail with the lower channel on the rear of the
test stand and slide the DIN rail through.
4. Secure the ends of the lower DIN rail to the wall using wall anchors
or other suitable fasteners.
5. Make calibration gas connections as shown in FIGURE 2-1.
6. Plug the power supply into the Test Stand power jack, which is
located on the bottom of the rear housing panel, toward the left-
hand side (when facing the Test Stand).
2-2
Figure 2-2. Wall Mounting