Publicité
Prescribed torque values for bolts supplied with the wheelchair lift and mounting set
Installer MUST verify that all bolted connections are fastened with the required torque in conformance with
this table.
After weight testing, installer MUST verify that all bolted connections between lift frame and mounting plates,
and between mounting plates and vehicle chassis are still tightened in conformance with the required torque.
Retighten if required.
Use a calibrated torque wrench to tighten bolt and nut connections to the prescribed torque value.
NOTICE
Incorrect, too soft or too hard tightening of mounting bolts can lead to accidental fall of the wheelchair lift
from the vehicle chassis.
A fall of the wheelchair lift from the chassis can damage the wheelchair lift and / or vehicle chassis and can
cause serious bodily injury or death to the operator and any bystanders.
Therefore, it is essential that the mounting plates are installed following the instructions of this manual.
MM.8.F04.S
Rev. 0
WARNING
www.dhollandia.com
page 3/10
Publicité
