Kenwood TK-2180 Mode D'emploi page 50

■
A R
UTO EPLY
You can set the transceiver to automatically respond to
Individual Calls (while using FleetSync):
1 Press the key programmed as Auto Reply Message to
enter Auto Reply Message mode.
• The Auto Reply Message indicator (
appears on the display.
2 When you receive an Individual Call, Auto Reply will
begin after waiting for 3 seconds, the transceiver will
send an automatic response to the caller, and "
" appears on the display.
• If you are available to receive the call, press any key to
disable the auto response.
• If memory is available on your transceiver for recording, "I
am not available. Leave your Message." will be sent to the
caller. The caller can then leave a recorded message on
your transceiver which you can later recall and listen to.
When a message is stored on your transceiver, "
appears on the display.
• If no memory is available on your transceiver for recording,
"I am not available." will be sent to the caller and "
42
M
ESSAGE
" appears on the display.
)
"