Kenwood TK-2180 Mode D'emploi page 36

■
T
RANSMITTING
1 Select your desired zone and channel.
2 Press the key programmed as Status to enter Status
Mode or Selcall + Status to enter Selcall Mode.
• When using the Status key to enter Status Mode, the
station ID is fixed and cannot be selected. Skip to step 5 to
continue.
3 In Selcall Mode, rotate the selector or press the <B and
C> keys to select the ID of the station you want to call.
• Alternatively, you can enter a station ID using the DTMF
keypad.
• If Manual Input Mode is enabled, you can enter digits by
using the DTMF keypad or by selecting digits with the
selector. To enter Manual Input Mode, first press and hold
the S or
a digit, then press the C> key to accept the digit and shift
the cursor to the right. Repeat this process until the entire
ID is entered.
4 Press the S or
5 Rotate the selector or press the <B and C> keys to
select the status ID you want to transmit.
• Alternatively, you can enter the status ID using the DTMF
keypad.
• If Manual Input Mode is enabled, you can enter digits by
using the DTMF keypad or by selecting digits with the
selector. To enter Manual Input Mode, first press and hold
the S or
a digit, then press the C> key to accept the digit and shift
the cursor to the right. Repeat this process until the entire
ID is entered.
6 Press the PTT switch or Side 2 key to initiate the Status
call.
• "
successfully transmitted.
28
key. When using the selector, rotate it to select
key to enter Status Mode.
key. When using the selector, rotate it to select
" is displayed when the call has been