Installation Instructions for Gas Conversion
5 CHANGE GRIDDLE ORIFICE
Locate the 3/4" long griddle orifice.
Select the proper orifice size for your gas and
burner from the conversion chart.
A. Lift off the griddle flue cover. Remove the 2 inside
clamping screws.
Griddle Flue Cover
Leveling Screws
Clamping
Screws
B. Lift out the cast-iron grease trough. Slide the
griddle toward the rear and out of the hold-down
tabs along the bottom.
C. Carefully lift and hold the griddle while pulling
additional length of the capillary from the entry
hole. Stand the griddle on end in the grease sump.
D. Remove the 2 hold-down screws at the rear of the
burner.
Pull the burner straight back toward the rear and
out of the gas inlet.
Back of Range
E. Use a 1/2" deepwell
socket to remove and
replace the orifice.
Reverse these steps to
reassemble the griddle.
Push excess capillary
back into the entry hole.
Place the unused orifice
in the holder for possible
future use.
24
(if present)
NOTE: Remove
the 2 screws
positioned on
the inside only.
Do not remove
the outermost
they are for
leveling.
Capillary
Front of Range
6A CHANGE MAIN BAKE BURNER
ORIFICE
Locate the 3/4" long bake burner orifice.
Select the proper orifice size for your gas and burner from
the conversion chart.
A. Remove the oven door and set aside in a safe
location.
B. Remove the 2 oven bottom hold-down screws
from the rear of the cover.
Hold-Down Screws
C. Slide the oven bottom forward and set aside.
D. Remove the burner diffuser screw.
E.
Clips
Diffuser screw
Lift the front of the burner diffuser up slightly and
slide it forward to disengage the clips at the rear.
Set the burner diffuser aside.
Burner
F. Remove the 2 burner retention screws.
G. Lift the front of the burner up slightly and slide
forward setting aside (careful not to damage the
igniter.)
H. Use a 1/2" deepwell
socket to remove
and replace the
orifice.
I. Reverse these steps
to reassemble the
oven burner and
oven parts. Place the unused orifice in the holder
for possible future use.
Oven
Bottom
Burner retention
screws
31-10755-4