Step 9, Check Burners; Oven Bake Burners; At Shutter - Monogram ZGP484NG Instructions D'installation

Masquer les pouces Voir aussi pour ZGP484NG:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

STEP 9
CHECK BURNERS
Check to be sure that burner heads and caps
are securely seated.
Burner Cap Properly Seated
Burner Cap Not Properly Seated
• Check for proper ignition:
– Push in one control knob and turn to LITE
position.
– The igniter will spark and the burner will light; the
igniter will cease sparking when the burner is lit.
– First test may require some time, while air is
flushed out of the gas line.
– Turn knob to OFF.
– Repeat the procedure for each burner.
IMPORTANT: If the igniter electrodes continue to
spark after the burners are lit, check that each
burner component is assembled properly. Refer to
the Owner's Manual.
• Burner flames should be blue and stable with no
yellow tips, excessive noise or lifting of the flame
from the burner. If any of these conditions exist,
check that the burner ports are not blocked. If one
of these conditions continues, call for service.
16
Installation
STEP 10
A. Remove the oven bottom and diffuser (refer to
sections 6A & B of the conversion installation
instructions, page 24).
B. To operate the Bake burner, turn the Oven Mode
Selector knob to Bake and turn the Oven Tem-
perature Knob to 350. After 30 to 90 seconds,
the burner will ignite.
Flames should be steady, approximately 1" blue
cones and, if range is supplied with natural gas,
should burn with no yellow tips. With most LP
gas, small yellow tips at the end of the outer gas
cones are normal. The inner cone of the flame
should be 1/2" to 3/4" long for either gas.
C. Perform the same check on the companion oven
if present.
STEP 11
To adjust the shutter:
1. If the flames are yellow, open the air shutter
more than the original setting.
2. If the flames blow away or flutter from the
burner, close the air shutter more than the
original setting.
The air shutter for the bake burner is
accessible by removing the burner.
A. Using a screwdriver, loosen the air shutter
adjustment screw.
CHECK OPERATION OF OVEN
BAKE BURNERS
ADJUSTING THE BAKE BURNER
AT SHUTTER (If necessary)
31-10755-4

Publicité

Table des Matières
loading

Table des Matières