Monogram ZGP484NG Instructions D'installation page 2

BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT
•
local inspector's use.
IMPORTANT
•
and ordinances.
Note to Installer
•
instructions with the Consumer.
Note to Consumer
•
with your Owner's Manual for future reference.
Completion Time
•
• Proper installation is the responsibility of the installer.
Product failure due to improper installation is not
covered under the warranty. See Owner's Manual for
warranty information.
WARNING:
This appliance must be properly grounded. Follow
directions in "Electric Supply" of this manual. Failure to
do so may result in electric shock.
For Monogram local service in your area,
1.800.444.1845.
For Monogram Service in Canada, call 1.800.561.3344.
For Monogram Parts and Accessories, call
1.800.626.2002.
If you received a damaged range, you should contact
your dealer.
In the Commonwealth of Massachusetts:
• This product must be installed by a licensed plumber
or gas fitter.
• When using ball type gas shut off valves, they shall be
T-handle type.
• A flexible gas connector, when used, must not exceed
3 feet.
WARNING:
All ranges can tip. Injury could result. Install the
supplied Anti-Tip Bracket provided. See instructions
in this manual or with the bracket.
If sold outside the U.S. and Canada:
WARNING:
with Liquefied Petroleum (LP) gas containing greater
than 10% butane, you must purchase the butane
conversion kit #WB28K10589. To order, please call
1.888.664.8403 or 1.787.276.4051. Failure to do so
may result in carbon monoxide or fire hazard.
2
Installation Instructions
Save these instructions for
Observe all governing codes
Be sure to leave these
Keep these instructions
1 to 3 hours.
If you wish to use this product
Vent hood Combinations:
A suitable overhead vent hood is required for models
with a grill and is recommended for all other models.
• Install a hood with at least 1200 CFM above a 48
wide range.
• Install a hood with at least 600 CFM above a 30" or
36" range.
Due to the high heat capacity of this unit, particular
attention should be paid to the hood and ductwork
installation to assure it meets local building codes.
WARNING:
Do not install this product with an air curtain hood
or other range hood that operates by blowing air
down on the cooktop. This airflow may interfere
with operation of the gas burners resulting in fire or
explosion hazard.
Clearances to horizontal surfaces above the range,
measured to the cooking surface are below. Failure to
comply may result in fire hazard.
• Installations without a hood require 48" minimum to
combustibles.
• A custom hood installation with exposed horizontal
combustibles surfaces must have an Auto-On
feature.
• For other installations with a hood, refer to hood
installation instructions for specific hood clearances.
CAUTION:
These ranges weigh up to 700 pounds. Some
disassembly will reduce the weight considerably. Due
to the weight and size of the range and to reduce the
risk of personal injury or damage to the product:
TWO PEOPLE ARE REQUIRED FOR PROPER
INSTALLATION OF 36" AND 30" RANGES.
THREE PEOPLE ARE REQUIRED FOR PROPER
INSTALLATION OF 48" RANGES.
Leak testing of the appliance shall be conducted
according to the manufacturer's instructions.
Installation must conform with local codes. In the
absence of local codes, the range must comply
with the National Fuel Gas Code, ANSIZ223.1/NFPA
54, latest edition and National Electrical Code ANSI/
NFPA 70 latest addition. In Canada, installation must
conform with the current Natural Gas Installation Code,
CAN/CGA-B149.1 or the current Propane Installation
Code, CAN/CGA-B149.2, and with local codes where
applicable. This range has been design-certified by CSA
International according to ANSI Z21.1, latest edition
and Canadian Gas Association according to CAN/CGA-
1.1 latest edition.
"
31-10755-4