Install Cover Panels - Monogram ZGP484NG Instructions D'installation

ZXADJB30PSS, ZXADJB36PSS, ZXADJB48PSS Accessory Installation

INSTALL COVER PANELS

See alternate method if side access is blocked.
• Hold the bottom cover over the bottom support
while driving one screw (provided) into each side.
• Place the top cover with shelf over the top wall
support. If you have access to the sides, secure the
panel with two screws on each side.
• Secure the top cover with shelf to the top support
with screws through the front of the panel, at the
top corners. Use one screw on each side.
Cover Panel
Install
Screw
Install Corner Screws
31-10755-4
INSTALL COVER PANELS (cont.)
ALTERNATE METHOD: When side access is blocked
• Install bottom cover over the bottom support while
driving one screw into each side.
• Hold top cover in place while marking screw
locations, just below shelf support and onto bottom
cover.
• Remove the shelf and drill a 9/64" diameter hole in
the pencil-marked locations.
• Mount the top cover over the top support and
secure the front cover with screws through the
drilled holes on each side.
• Install screws through each top corner.
Install
Screw
Install Screw
on Each Side
Install Screw in Top Corner on Each Side
Mark Screw
Locations for
Alternate Method
Shelf
21