WMF 06 3286 6044 Mode D'emploi page 21

To alter the setting of the lid brakes, undo the locking screw and turn the adjusting nuts on both
sides of the lid in the desired direction (Fig.1):
1
to slacken off
Towards
Then replace the screws in the brakes and tighten them up.
Important:
adjust by the same number of holes at each side.
•
Replace the locking screws and screw tight
•
Replace the lid
b) CHANGE series round rolltop chafing dishes
These chafing dishes are fitted with a brake that does not require to be adjusted in use.
The lid can be locked at 90° and at 180° and can easily be opened when using electric heating.
This plastic bearing has several advantages:
1. The lid travels in the bearing and the special shape of the plastic part acts as a stop.
2. This braking action prevents the lid from swinging back noisily.
3. The bearing allows the lid to be opened and locked at angles of 90° and 180°. The 180° open
position is the limit stop.
NOTE: The lid should be closed smoothly, without jerking, from the 180° open position to avoid
tipping the chafing dish forward.
4. The plastic bearing is screwed on to the chafing dish frame. If a defect occurs it can simply
be unscrewed and replaced by the customer at any time.
5. The heating cable is retained by a clip in the plastic bearing and is routed to the front of the
chafing dish (see illustration).
2
to tighten up
Towards
21