Operation Of The Tool - Titan TA 220 Mode D'emploi

6.2.

Operation of the tool

Route the TITAN plastic strap from the top around
the packing item.
Only use plastic strap which is free of grease, oil
etc.
When inserting the strap pull the end of strap
through until it is in the middle of the packing item
under the upper strap and protrudes by one length
of hand.
Use your left hand to hold both straps exactly lying
above one another. Pull lever 3 to the grip by
means of your right hand and hold it. Pull both
straps to the stop along the side of the housing
wall into the tool. Hereby, the lower strap must
protrude a little out of the tool.
Pull both straps to the stop along the side of the
housing wall into the tool.
If required, draw the big strap loop together. In
doing so, your left hand pulls the strap loop; your
right hand takes lever 3.
Then release lever 3 again.
For tensioning the strap press pushbutton 1 and
keep it pressed, until the strap tension desired is
achieved.
After releasing pushbutton 1 it can still be actuated
maximum 3 times to increase strap tension.
29 / 64
TA 220
H TA 220 EU 37/09