Miele PWM 912 Mode D'emploi page 72

en - Programme summary
Mops ch-th dis 20min+rtu 60 °C
Fabric
Programme se-
quence
Extras
Mops rtu
Fabric
Programme se-
quence
Extras
New mops
Fabric
Programme se-
quence
Extras
* The disinfection parameters for chemo-thermal disinfection (temperature, temperature holding time and dispensing
quantities) must be set on site to suit cleaning agents and disinfectants.
72
Cotton, viscose, polyester and microfibre mops
Programme sequence as for Mops chemo-
thermal disinfection*,
then set the residual moisture via the extra " –
" (moist, damp, wet, dripping wet)
The pre-set residual moisture is 2 drops (damp)
Pre-rinse, Soak, Intensive, Rinse plus, Add agent,
Rinse hold
Cotton, viscose, polyester and microfibre mops
1 rinse cycle
then set the residual moisture via the extra " –
" (moist, damp, wet, dripping wet)
The pre-set residual moisture is 2 drops (damp)
Add agent, Rinse hold
60 °C (Cold to 90 °C)
For washing new mops
Main wash up to 90 °C, wash time 4 min
Cool down can be activated in the Benchmark
tool
2 rinse cycles
Final spin
Soak, Water plus, Intensive, Rinse plus, Add
agent, Rinse hold
Load ratio/Load
size
1:10
PWM 912 – 11 kg
PWM 916 – 14 kg
PWM 920 – 18 kg
1:9
PWM 912 – 12 kg
PWM 916 – 16 kg
PWM 920 – 20 kg
For number,
see
"Mops load size"
chart