Miele PWM 912 Mode D'emploi page 71

Mops ch-th disinf 10 min
Fabric
Programme se-
quence
Extras
Mops ch-th disinf 20 min
Fabric
Programme se-
quence
Extras
Mops ch-th dis 10 min
+rtu
Fabric
Programme se-
quence
Extras
* The disinfection parameters for chemo-thermal disinfection (temperature, temperature holding time and dispensing
quantities) must be set on site to suit cleaning agents and disinfectants.
70 °C
Cotton, viscose, polyester and microfibre mops
Pre-spin
Pre-rinse bath
Second pre-rinse bath can be activated via ex-
tra  "Pre-wash"
Disinfection* 70 °C, holding time 10 min
3 rinse cycles (optional disinfection rinse can be
activated)
Final spin
Pre-rinse, Soak, Intensive, Rinse plus, Add agent,
Rinse hold
60 °C
Cotton, viscose, polyester and microfibre mops
Pre-spin
Pre-rinse bath
Second pre-rinse bath can be activated via ex-
tra  "Pre-wash"
Disinfection* 60 °C, holding time 20 min
3 rinse cycles (optional disinfection rinse can be
activated)
Final spin
Pre-rinse, Soak, Intensive, Rinse plus, Add agent,
Rinse hold
70 °C
Cotton, viscose, polyester and microfibre mops
Programme sequence as for Mops chemo-
thermal disinfection*,
then set the residual moisture via the extra " –
" (moist, damp, wet, dripping wet)
The pre-set residual moisture is 2 drops (damp)
Pre-rinse, Soak, Intensive, Rinse plus, Add agent,
Rinse hold
en - Programme summary
Load ratio/Load
size
PWM 912 – 11 kg
PWM 916 – 14 kg
PWM 920 – 18 kg
1:10
71