Seca 684 Mode D'emploi Et Garantie page 79

3. Ensure that the display cable is routed in the top
cross-piece in such a way that it cannot become
trapped in subsequent assembly steps.
4. Put the caps on the cross-piece.
5. Ensure that the bores of the caps are precisely over
the bores of the cross-piece.
6. Put a screw in each of the outer bores of the caps
and tighten them up.
7. Put the display support on the cross-piece.
8. Ensure that the bores in the cross-piece are pre-
cisely over the inner bores of the caps and of the
cross-piece.
9. Put a screw in each of the bores of the display
support and tighten it up.
10. Connect the display cable to the electronics box on
the weighing platform.
Before you really get started ... • 79
English