Seca 684 Mode D'emploi Et Garantie page 74

5.2 Assembling the device
Fitting the side parts
74 •
We recommend that two people perform the assembly,
as large individual parts have to be aligned with one
another and screwed together.
You need the following fastenings for this assembly
step (fitted to the weighing platform):
6 x M6 x 16
1. Remove the nuts and toothed rings on both sides
of the weighing platform.
2. Leave the screws in the bores.
3. Place the weighing platform on its front edge and
hold it in this position.
4. Put the right-hand side part on the screws on the
weighing platform.
5. Put one toothed ring and one nut on each of the
screws.
6. Tighten up the nuts.
7. Repeat steps 4. to 6. for the left-hand side part.
6 x J 6.4 6 x M6