Table Des Matières; Design Information; Models Available; Product Dimensions And Clearances - Monogram ZV750 Instructions D'installation

CONTENTS
Design Information
Models Available ................................................................................ 3
Product Dimensions ......................................................................... 3
Advance Planning
Ductwork Planning .......................................................................... 4
Wall Framing for Adequate Support ....................................... 4
Advance Planning ............................................................................ 4
Installation Preparation
Duct Fittings ......................................................................................... 5
Power Supply ...................................................................................... 6
Tools and Materials Required ...................................................... 6
Remove the Packaging ................................................................. 7
Check Installation Hardware ...................................................... 7
Determine Installation Height ..................................................... 8
Installation Instructions
Installation - Vented to the Outside ..................................9-13
Step 1, Install Framing for Hood Support .............................. 9
Step 2, Install Mounting Brackets ............................................10

MODELS AVAILABLE

Model ZV750
Model ZV755
These hoods may be installed to vent to the outdoors,
or they may be installed for recirculating operation.
All necessary parts for recirculating operation are
supplied with the hood. No kits required.
• These vent hoods can be installed over any 30 or 36
Monogram electric or gas cooktop except Monogram
Professional cooktops or ranges larger than 30 .

PRODUCT DIMENSIONS AND CLEARANCES

The vent hood must be installed 24 minimum, and
30 maximum above the cooking surface.
NOTE: Installation height should be measured from
the cooking surface to the lowest part of the hood.
24 Minimum
30 Maximum
36 Minimum

Design Information

Step 3, Install the Hood ................................................................10
Step 4, Install Duct Bracket ........................................................11
Step 5, Connect Ductwork ..........................................................12
Step 6, Connect Electrical ............................................................12
Step 7, Install Duct Cover and Utensil Rods .......................13
Step 8, Install Filters .......................................................................13
Step 9, Finalize Installation .........................................................13
Installation Instructions
Installation - Recirculating .................................................14-18
Step 1, Install Framing for Hood Support ............................14
Step 2, Install Mounting Brackets ............................................15
Step 3, Install the Hood ................................................................15
Step 4, Assemble Deflector and Connector ........................16
Step 5, Size Duct Piece ..................................................................16
Step 6, Install Air Deflector Assembly ....................................16
Step 7, Connect Electrical ............................................................17
Step 8, Install Duct Cover and Utensil Rods .......................17
Step 9, Install Filters .......................................................................18
Step 10, Finalize Installation.......................................................18
• Reversible duct covers accommodate recirculating
• The telescopic duct covers conceal the ductwork
• The supplied duct cover is sized to reach ceiling heights
This accessory is available for installations with
ceiling heights above 9' to 10' and higher. See the table
on page 8.
The duct cover accessory must be on-site with the
hood at the time of installation.
3
operation.
running from the top of the hood to the ceiling.
up to 9' or more, depending on the installation. See the
table on page 8.
35-3/8" (excluding utensil rods)
36-1/2" (including utensil rods)
*Height
to Ceiling
8-1/4"
27-1/2"