SRAM QUARG Mode D'emploi page 8

I N S T A L L A T I O N
M A G N E T I N S T A L L A T I O N
The included magnet must be installed for the power meter to function. There are three ways to install the
magnet: BB Cup Mount, Cable Guide Mount, and Adhesive Putty (only one type of mount can be use at a
time). When properly installed, the magnet should be in line with the cadence sensors and within 2-­8 mm
of the sensors. If necessary, magnets may be stacked to achieve the proper distance to the sensor. Do
not allow the magnet to contact the power meter.
It is easier to install the magnet when the cranks are not installed on the frame.
Cable Guide Mount
BB Cup Mount
Adhesive Putty
6
INSTALLATION