Starting The Refrigerator Using Electricity; Regulating The Temperature; Kerosene Operation; Electrical Operation - Sibir V110 Mode D'emploi

StARtINg thE REFRIgERAtoR uSINg ElEctRIcIty

1 Check that the voltage is correct.
2 If lit, turn off the burner flame.
3 Plug in the power supply cable.
4 Turn the control knob to a medium position and leave the refrigerator on for 3–4 hours.
5 Check the inside temperature and adjust the control knob if necessary.
!
• The kerosene burner must never be lit when electricity is used.
• First time the refrigerator is used, smoke will appear due to paint residues in the
heater tube.

REgulAtINg thE tEmPERAtuRE

KeRoSene oPeRATIon

1 For good temperature control, the burner should be lit constantly. The refrigerator temperature depends on the flame
size. It is regulated by the control knob.
2 High flame gives a colder refrigerator. low flame gives a warmer refrigerator.
AlAddIN buRNER
Low Medium

eleCTRICAl oPeRATIon

After checking the inside temperature, the control knob can
be turned towards a warmer or colder position. Any suit-
able position between no "1" and "MAX" could be used.
This knob is graduated from 0 (marked by a spot) to figure
7 and MAX position where the cabinet is set for continual
operation, i.e. the thermostat is by-passed. Refrigerator
temperature is controlled by the thermostat only when run-
ning on electricity. When running on kerosene, the tempera-
ture is controlled by means of the knob on the front of the
refrigerator.
www.sibir.com
Maximum (high)
KoSmoS buRNER
Very low Low Medium Maximum (high)
copyright © sibir international
9