Replacing The Thermostat; Replacing The Heater - Sibir V110 Mode D'emploi

REPlAcINg thE thERmoStAt

1 Remove the plug from the wall socket.
2 Remove the capillary tube end at the cooling element
and pull it carefully out from the rear of the cabinet
3 Remove the plastic cover and the wires from the
thermostat.
4 Remove fastening screws or nuts and pull the
thermostat out.
5 Fit the new thermostat.
6
6 Connect the wires and replace the plastic cover.
7 Reattach the capillary tube.
8 Plug into the wall socket.

REPlAcINg thE hEAtER

1 Remove the plug from the wall socket.
2 Remove the terminal cover and loosen the heater
cables.
3 look for a small cover on the boiler case and
remove it.
4 lift the heater and take it out.
5 Insert the new heater into the heater tube.
6 Make sure that the glass wool is put back around
the heater and fit the cover again.
7 Connect the cables and fit the terminal cover in
reverse order.
8 Put the refrigerator on test.
www.sibir.com
6
!
• be CAReFUl noT To bReAK THe CAPIllARy
TUbe!
• Make sure that the capillary tube makes contact
with the cooling element only where it is to be
fastened.
Cover
Heater
Terminal box
18
copyright © sibir international