Replacing The Wick; Aladdin Burner - Sibir V110 Mode D'emploi

REPlAcINg thE WIcK

AlAddIn bURneR

1 Remove the tank.
2 Remove the control knob from the burner and lift the burner from the tank.
3
3 Remove the gallery by turning it anti-clockwise.
4
4 Remove the flame spreader.
5
5 Remove the outer wick tube by turning it anti-clockwise and pull it out of the burner.
6 Turn the wick up as far as possible.
7
7 Pull the wick and the wick carrier out from the burner.
8 Pull the wick and wick carrier apart.
8
9 Unpack a new, dry and clean wick. do not fray the wick.
10 new wicks have adhesive papers at the tail ends. Straighten these out, but do not remove them.
11 Pull the paper tails through the opening around the wick tube.
11
12 12 Pull the papers until the wick ends are through the opening at the bottom of the burner.
7
www.sibir.com
3
4
8
11
copyright © sibir international
15
5
12