Sibir V110 Mode D'emploi page 7

lIghtINg thE buRNER
3 3 light the wick and allow the flame to travel around
the wick.
4 Replace the gallery together with the lamp glass and
sealing ring by turning it clockwise.
5
5 Turn the flame down to the smallest possible flame.
6 Push the tank into the tank holder underneath the
6
cabinet at the rear of the refrigerator. Slide the tank
carefully forwards against the guide pin.
7 Carefully lift the tank by means of the lever arm
7
and check that the guide pin enters the hole in the
bracket on the left side of the burner.
8
8 Make sure that the sealing ring seals properly
against the chimney. There must be no gap between
the chimney and the sealing ring.
9 Adjust the flame to medium flame and leave the
refrigerator running for 3–4 hours.
10 For further adjustment, see "Regulating the tempera-
ture > Kerosene operation".
6
7
www.sibir.com
!
Lever arm
Lever arm
Gallery
5
• never let the flame burn yellow or with yellow
streaks, see "Troubleshooting charts".
• never turn the flame to maximum until the
chimney has been heated for 3–4 hours.
• First time using the refrigerator, smoke will
appear due to paint residues in the chimney.
Guide pin
8
8
3
Low flame
Sealing
ring
Sealed
Sealing
ring
Not sealed
copyright © sibir international
7