Setting The Operating Temperature; Indicator Lights - Sibir GS 110 A Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

en
Setting the operating
temperature
(Fig. 2)
The operating temperature is regulated by the
temperature control.
Warm
1
(Or) Min.
1 = Lowest cooling setting (Warmest setting)
4 = Highest cooling setting (Coldest setting)
(Or)
Min. = Lowest cooling setting
(Warmest setting)
Max. = Highest cooling setting
(Coldest setting)
Please choose the setting according to the
desired temperature.
The interior temperature also depends on
ambient temperature, the frequency with which
the door is opened and the amount of food
kept inside.
Frequently opening the door causes the interior
temperature to rise.
For this reason, it is recommended to close
the door again as soon as possible after use.
The normal storage temperature of your
appliance should be -18 °C (0 °F). If the
thermostat knob is turned counter clockwise
from position 1, the appliance will be switched
off and "click" sound will be heard. Lower
temperatures can be obtained by adjusting
the thermostat knob towards Position 4.
We recommend checking the temperature
with a thermometer to ensure that the storage
compartments are kept to the desired
temperature. Remember at take the reading
immediately since the thermometer
temperature will rise very rapidly after you
remove it from the freezer.
Cold
2
3
4
Max.

Indicator lights

There are three coloured indicator lights located
on the front of the appliance which shows the
operating mode of the freezer. (Fig. 2)
Green Indicator (1) Illuminates when the
appliance is connected to the mains and will
glow as long as electricity is available. The
green light will not glow if the thermostat is
set to '0' position. The green indicator does
not give any indication of the temperature
inside the freezer.
Amber Indicator (2) This indicator will glow
when the fast freeze switch (4) is on and will
continue to glow until the fast freeze switch is
turned off. The compressor will run
continuously while fast freeze switch is on.
Fast freeze operation is for freezing fresh food.
Red Indicator (3) Illuminates:
a) If the pre-set temperature can not be
maintained.
b) If excessive amounts of fresh food are
placed inside.
c) If the appliance door is left open accidentally.
Thermostat knob (5) Thermostat knob is
located on the indicator light set.
IMPORTANT:
When you press the fast freeze switch, there
may be a short delay before the compressor
starts to operate. This is normal and does not
indicate a compressor fault.
4
en

Publicité

Table des Matières
loading

Table des Matières