Monthly Operational Actions; Checking The Door Seal; Defrosting - Sibir V110 Mode D'emploi

moNthly oPERAtIoNAl ActIoNS

1 Check that the condenser and cooling unit are free
1
from dust.
2 Check the outer cabinet for paint damage. Repaint
if necessary.
!
When necessary:
• Clean the refrigerator in and outside with a
damp cloth. Use mild detergent only!
• Clean door gasket.

chEcKINg thE dooR SEAl

1 Place a thin paper strip against the cabinet
1
front.
2 Close the door.
2
3 Pull the paper strip, if it moves easily or falls
away by itself:
• Find the place where the rubber gasket
doesn't seal tightly, then ...
• Place a pad of paper or sticking plaster
between the rubber gasket and the inside
of the door in order to make the gasket seal
tightly.
4 If you can not make the door seal tightly, order a
new door.

dEFRoStINg

It is normal that frost forms on the cooling element. A thin layer of frost does not affect the
cooling performance. A thick layer of frost (6–10 mm (0.24-0.39") or more) must be removed
by defrosting.
1 Move the vaccine to another refrigerator if available or
store it in a coolbox with ice packs.
2 blow out the flame or pull the plug from the wall socket
and leave the door and the freezer compartment shutter
open.
3 Remove ice with your fingers, as soon as it is possible
to do so. do not use knives or sharp instruments!
4 empty the drip tray.
5 Wipe the freezer compartment and cooling element dry.
6 Clean the refrigerator inside. Use mild detergent only.
7 Start the refrigerator on kerosene or electricity.
www.sibir.com
1
!
• Check all the way around the door.
• Pay particular attention to the corners.
!
• defrosting is to be carried out as
quickly as possible in order not to
damage the vaccine.
• Use the time it will take to defrost to
clean the refrigerator etc.
• Wait until the vaccine compartment is
cold before replacing the vaccine.
1
2
copyright © sibir international
11