Inserting / Replacing Batteries - LIVARNO LUX 304540 Instructions De Montage, D'utilisation Et Consignes De Sécurité

Note: The built‑in charging controller of the product prevents the
rechargeable batteries 11 from overcharging.
Replace the rechargeable batteries 11 if light output does not
improve after charging (Fig. C: HG04465A or Fig. E: HG04465B).
˜ Inserting / replacing batteries
Note: The rechargeable batteries 11 are pre‑installed. Only use
batteries as stated in the "Technical data" chapter. To remove the
rechargeable batteries 11 , switch the spotlight 3 off using the ON/
OFF switch 2 .
Open the battery compartment 12 on the back side of the
spotlight 3 by loosening the fixing screws 13 counterclockwise
to remove the front cover 10 (Fig. C: HG04465A or
Fig. E: HG04465B).
Remove the old rechargeable batteries 11 .
Insert the new rechargeable batteries 11 . Use only batteries of
the specified type (see "Technical data").
Note: When inserting the battery, ensure the correct polarity!
This is indicated in the battery compartment 12 .
Close the battery compartment 12 again with the front cover
10 and fix the front cover 10 by turning the fixing screws 13
clockwise.
GB/IE/NI 13